- Download pronterface 2.0.0 for Mac from our software library for free. Pronterface for Mac belongs to System Tools. The most recent installation package that can be downloaded is 34.4 MB in size. The actual developer of this free software for Mac is Kliment.
- Properly adjusting your steps/mm to account for your newly mounted syringe extruder is a critical step to enable FRESH Printing. Converting a filament extrud.
Drivers and manuals Drivers Version 2.1.5 Most recent (May 8, 2018) for MK3 and MK2/S/MMU. Check and download from here all Creality Firmware & Files for free!Visit the Creality3D official online store to learn, buy, and get support.
I looked all over for the best resource to level my BL Touch probe. Finally, I found one on YouTube from 3DMN.
Pronterface For Mac
Follow these instructions to calibrate your 3D printers BLTouch bed leveling probe sensor.
Pronterface Mac Port
What software do I need?
You can use any software that allows you to enter commands in your 3D Printer terminal/console including:
- Pronterface (https://www.pronterface.com/)
- Raspberry Pi 3 or 4 with OctoPrint / Octopi (https://octoprint.org/)
BL Touch Z-offset Leveling Instructions
Connect your computer to your 3D Printer using a USB cord and launch Pronterface.
Pronterface Mac Usb Port
Pronterface Macros
- Home your 3D printer
- Reset Z0-Offset
- Store setting to EEPROM
- Set active parameters
- Display Active Parameters
- Home your nozzle and show your Z-Axis
- Move the nozzle to true 0 offset
- Switch off soft end stops
- Get a piece of letter/A4 paper and place it under your nozzle
Lower your nozzle towards bed slowly until the paper can barely move - Take note of the Z on the printer display (take that number and add the measurement of the calibration sheet or device used)
- Set your z offset. Mine measured -2.7 so I used -2.71.
- Enable Soft Endstops
- Save settings to Eeprom
- Set Active Parameters
- Display current settings
- Again, Tell the printer to go Home
- Move the nozzle to true zero offset to see your result